How do I increase my bandwidth?
Go to RUN.

type gpedit.msc

go to computer configuration >administrative templetes > network > QoS packet scduler > Limit reservable Bandwidth enable it.

set it to 0 percentage.This settings Determines the percentage of connection bandwidth that the system can reserve. This value limits the

combined bandwidth reservations of all programs running on the system.By default, the Packet Scheduler limits the system to 20 percent of the bandwidth of a connection, but you can use this setting to override the default.If you enable this setting, you can use the "Bandwidth limit" box to adjust the amount of bandwidth the system can reserve.If you disable this setting or do not configure it, the system uses the default value of 20 percent of the connection.If u change it to 0 then the 20 % incrase in your bandwidth

Boost Extreme Speed to your BroadBand Connection..
A. in the "My Network Places" properties (right click on the desktop icon and choose properties), highlight the connection then at the menu bar choose "Advanced" then "Advanced Settings". Uncheck the two boxes in the lower half for the bindings for File and Printer sharing and Client for MS networks. Click OK
B. Continue as indicated below steps:
1. from the Windows XP CD in the support directory from the support cab, extract the file netcap.exe and place it in a directory on your hard drive or even in the root of your C:\ drive.
2. next, open up a command prompt window and change directories to where you put netcap.exe then type "netcap/?". It will list some commands that are available for netcap and a netmon driver will be installed. At the bottom you will see your adapters. You should see two of them if using a 3Com card. One will be for LAN and the other will be for WAN something or other.
3. Next type "netcap/Remove". This will remove the netmon driver.
4. Open up control panel / system / dev man and look at your network adapters. You should now see two of them and one will have a yellow ! on it. Right click on the one without the yellow ! and choose uninstall. YES! you are uninstalling your network adapter, continue with the uninstall. Do not restart yet.
5. Check your connection properties to make sure that no connection exists. If you get a wizard just cancel out of it.
6. Now restart the machine and go to your connection properties again and you should have a new connection called "Local area connection 2". highlight the connection then at the menu bar choose "Advanced" then "Advanced Settings". Uncheck the two boxes in the lower half for the bindings for File and Printer sharing and Client for MS networks. Click OK.
8. Choose connection properties and uncheck the "QOS" box
9. Restart the machine and enjoy the increased responsiveness of IE, faster page loading, and a connection speed boost...

tweek ur broadband connection.
basically after getting to the hidden config settings you set the browser to request more data that it usually does.

step 1.Type "about:config" into the address bar and hit enter. Scroll down and look for the following entries:

network.http.pipelining

network.http.proxy.pipelining

network.http.pipelining.maxrequests

Normally the browser will make one request to a web page at a time. When you enable pipelining it will make several at once, which really speeds up page loading.

2. Alter the entries as follows:

Set "network.http.pipelining" to "true"

Set "network.http.proxy.pipelining" to "true"

Set "network.http.pipelining.maxrequests " to some number like 30. This means it will make 30 requests at once.

3. Lastly right-click anywhere and select New-> Integer. Name it "nglayout.initialpaint.delay" and set its value to "0". This value is the amount of time the browser waits before it acts on information it receives.

If you're using a broadband connection you'll load pages MUCH faster now!